Previous Series

Home > Products > Previous Series > SPS.16.STS
SPS.16.STS
  • SPS.16.STS UPS
  • SPS.16.STS SALICRU
 
PDF
Data Sheet es ca en fr
PDF
Manual SPS.16.STS es
 
PDF
Safety instructions es en fr de pt
PDF
General Catalogue es ca en fr de pt
 

SPS.16.STS

Automatic transfer system 16 A

Redundancy in power supply sources

The SALICRU SPS.16.STS is basically an automatic, single phase switch with two input AC lines, which uses two sine-wave power supply sources to provide output voltage to load/s. 

 

The SPS.16.STS is factory programmed with mains 1 as priority and mains 2 as reserve. Users can change this using the communication software. Each time the SPS.16.STS is started, the system will start up with the criteria established the last time it was programmed.

 

It is possible to switch from mains 1 to mains 2 or vice versa using the BP2 pushbutton, and this change is recorded in the internal memory.

 

The power supply of the load/s is transfered from one mains to the other if the voltage and/or frequency of the priority source is off-margins. The LEDs on the control panel report the state of the equipment and operation at all times, and this panel is an easy-to-understand, practical interface for any operator.

Request information

Applications

Applications

Features

  • Break Before Make.
  • Automatic backfeed protection, as per standard EN 62310-1.
  • Overloading and short-circuit protection in both networks (using accessible fuses and 10A thermal relays).
  • Redundant power system (of network 1 input power source and network 2 input power source).
  • Alternating current detector (voltage and current detector).
  • Output detector (current detector).
  • Control panel to LED.
  • Auxiliary contact for external RPO.
  • IP30 protection index.
  • The SPS.16.STS can transfer with P/N input wiring error.
  • The two system inputs can be different phases of the same three-phase N/R and N/S network.
  • Audible alarm silencer.

Display

  1. Load supplied from PS1 priority mains.
  2. State of the PS1 mains.
  3. PS1 mains selected.
  4. PS1 or PS2 mains selector.
  5. PS2 mains selected.
  6. State of the PS2 mains.
  7. Load supplied from PS2 secondary mains.
  8. Alarm indication.
  9. Alarm silencer.
Display SPS.16.STS - SALICRU

Previous View

  1. LED display.
  2. RPO.
  3. RS-232.
  4. Dry contact interface
Previous View SPS.16.STS - SALICRU

Rear View

  1. IEC320-C20 type inputs.
  2. IEC320-C19 type outputs.
  3. 10A output thermal protection.
  4. IEC320-C13 type outputs.
  5. Input protection fuses.
Rear View SPS.16.STS - SALICRU

Techinical Specifications

Technical Specifications SPS.16.STS

Range

Range SPS.16.STS