Professional

UNMS II Software

For those networks which have more than one UPS to feed it and it requires a concentration monitoring from a single command post, UNMS II software (UPS Network Managament System) is the ideal solution. UNMS II allows managing multiple installations of all those units that have an Ethernet adapter SNMP / Web Adapter and / or sensors. UNMS II packages are available in 9, 25, 50 or 150 licenses.

RCCMD Software

UPS managing and monitoring in a heterogeneous IT networks, where different platforms coexist, becomes almos impossible, because the less common operating systems on the market do not have that such software.The RCCMD is an application that allows the simultaneous and secure shutdown of the 95% of existing platforms. Like the most comprehensive monitoring software, the RCCMD can send messages or commands to different clients of the network.

BACS II

Monitoring, managing and alarm system for lead-acid batteries. Ensures the full operation of the battery system, preventing unexpected or unnoticed failures caused by defective batteries. System Components: WebManager, battery modules, associated bus

Ethernet/SNMP Web Adapter

SNMP adapter to integrate the equipment in a IT network by using an IP address. It includes adapter, CD with programming software, configuration cable, MIB (Management Information Base) and user manual. Available in card or box formats.

Temperature and humudity sensor

Probe to measure the magnitude of the battery ambient temperature and humidity of the equipment

AS-400 card

AS-400 card allows obtaining the following alarms: UPS fault, general fault low battery, UPS ON and mains failure in a dry contact way.  In the big units  AS-400 card allows a remote shutdown of the equipment and getting dry contacts of the following alarms: UPS fault, general alarm (it includes: UPS fault, mains failure, low battery, bypass active), UPS on bypass, low battery, UPS on inverter and mains failure. td> 

MODBUS Protocol

Public and industrial communication protocol that allows controlling and monitoring of the device. Communication over an RS-232 port.

RS485 Port

It allows extending the communication functions of an equipment through a RS-485 or Ethernet connection. Format card.

Potential-free contacts

These are potential-free relays that are used to receive an on/off signal for the automatic operation of a device.

Battery modules

For backup requirements greater than standard, one or several battery modules connected to the UPS can be installed.

Static Transfer System (STS)

16A transfer system with RS-232 communication port and dry contact port, which allows the user to choose the feeding of the load from two different power supplies and to set the tolerance range of the priority mains, among other parameters.

External manual bypass

External Manual Bypass to make maintenance tasks, by isolating the equipment electrically. Bypass type make Before break

Autotranformer for other voltages

It used to adapt the equipment to other different nominal voltages 3x380 / 400/415 + N V.

Isolation transformer

Electrical device that provides galvanic isolation between input and output, and adjust tension.